LPC800 Mikrokontroler ARM Dengan Kemasan DIP

• System:
  • ARM Cortex-M0+ processor, running at frequencies of up to 30 MHz with single-cycle multiplier and fast single-cycle I/O port
  • ARM Cortex-M0+ built-in Nested Vectored Interrupt Controller (NVIC)
  • System tick timer
  • Serial Wire Debug (SWD) and JTAG boundary scan modes supported
  • Micro Trace Buffer (MTB) supported
• Memory:
  • 4 kB on-chip flash programming memory
  • 1 kB SRAM
• Boot ROM API support:
  • Boot loader
  • USART drivers
  • I²C drivers
  • Power profiles
  • Flash In-Application Programming (IAP) and In-System Programming (ISP)
• Digital peripherals:
  • High-speed GPIO interface connected to the ARM Cortex-M0+ IO bus with 6 General Purpose I/O (GPIO) pins with configurable pull-up/pull-down resistors
  • GPIO interrupt generation capability with boolean pattern-matching feature on eight GPIO inputs
  • Switch matrix for flexible configuration of each I/O pin function
  • State Configurable Timer (SCT) with input and output functions (including capture and match) assigned to pins through the switch matrix
  • Multiple-channel multi-rate timer for repetitive interrupt generation at up to four programmable, fixed rates
  • Self Wake-up Timer (WKT) clocked from either the IRC or a low-power, low-frequency internal oscillator
  • CRC engine
  • Windowed Watchdog timer
• Analog peripherals:
  • Comparator with external voltage reference with pin functions assigned or enabled through the switch matrix
• Serial interfaces:
  • Two USART interfaces with pin functions assigned through the switch matrix
  • One SPI controller with pin functions assigned through the switch matrix
  • One I²C-bus interface with pin functions assigned through the switch matrix
• Clock generation:
  • 12 MHz internal RC oscillator trimmed to 1 % accuracy that can optionally be used as a system clock
  • Crystal oscillator with an operating range of 1 MHz to 25 MHz
  • Programmable watchdog oscillator with a frequency range of 9.4 kHz to 2.3 MHz
  • 10 kHz low-power oscillator for the WKT
  • PLL allows CPU operation up to the maximum CPU rate without the need for a high-frequency crystal. May be run from the system oscillator, the external clock input CLKIN, or the internal RC oscillator
  • Clock output function with divider that can reflect the crystal oscillator, the main clock, the IRC, or the watchdog oscillator
• Power control:
  • Integrated PMU (Power Management Unit) to minimize power consumption
  • Reduced power modes: Sleep mode, Deep-sleep mode, Power-down mode, and Deep power-down mode
  • Power-On Reset (POR)
  • Brownout detect
• Unique device serial number for identification
• Single power supply
• Available as DIP8 package

Referensi

• http://www.nxp.com/products/microcontrollers/cortex_m0_m0/LPC810M021FN8.html